Engine
11
5. Disconnect the primer hose. See Figure 2.12.
6. Disconnect the harness that connects to the safety
switch.
NOTE: If equipped with remote chute control:
7. Remove the nut and bolt (indicated by the arrow in
Figure 2.13.) that attach the universal joint to the
chute rotation rod using a #2 phillips screw driver and
a 5/16” wrench.
8. Squeeze the trigger while pulling out on the joystick
until there is enough room to separate the universal
joint from the control rod.
9. Remove the hair pin clip (indicated by the arrow in
Figure 2.14.) that secures the control rod to the pin-
ion gear.
10. Remove the control rod and the washer.
Figure 2.12
Primer hose
Safety switch
Figure 2.13
Figure 2.14
To Next Page
Loading...
