5.12 Stopping the engine at the BlueLine automation system
(control stand)
NOTICE
Stopping the engine when it is running at full load causes extreme stress to the engine.
Risk of overheating, damage to components!
• Before shutting down, disengage gear and run the engine at idle speed for at least 10 minutes until
engine temperatures have dropped and constant values are displayed.
Stopping the engine at the BlueLine automation system (control stand)
Item Measure
Engine Stop the engine at the BlueLine automation system (control stand) (→ Blue-
Line Operating Instructions).
MW15409/04E 2015-08 | Operation | 47
TIM-ID: 0000002702 - 005
To Next Page
Loading...