EasyManua.ls Logo

MTU C13 - Page 75

MTU C13
163 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Fault code No. Full designation Meaning Action
Related
parameter
No.
449 SS P-Charge Air
Alarm configuration limit val-
ue 2; Main warning: Charge-
air pressure too high. Contact Service.
2.0103.93
2
450 SD Feed Signal Percent
SD alarm configuration; Input
signal for initial/final torque
faulty; Short circuit or wire
break
Check signal trans-
mitter and cabling,
replace as necessa-
ry.
Error cleared after
restarting the en-
gine.
2.8006.59
2
454
SS Power Reduction Ac-
tive
Alarm configuration; Power
reduction is active.
1. Note further fault
messages.
2. Determine and
rectify reason for
power reduction.
2.7000.01
1
455 AL Aux 1 Plant L1
Alarm configuration limit val-
ue 1; Input signal of Aux 1
(plant side) has
exceeded/not attained limit
value 1, depending on config-
uration.
Determine cause of
limit value violation
and rectify fault.
2.8006.65
0
456 AL Aux 1 Plant L2
Alarm configuration limit val-
ue 2; Input signal of Aux 1
(plant side) has
exceeded/not attained limit
value 2, depending on config-
uration.
Determine cause of
limit value violation
and rectify fault.
2.8006.65
1
460 AL Exhaust EMU High
Alarm configuration limit val-
ue; EMU exhaust gas temper-
ature value too high.
1. Check cabling.
2. Contact Service.
2.8006.65
2
461 AL Exhaust EMU Low
Alarm configuration limit val-
ue; EMU exhaust gas temper-
ature value too low.
1. Check cabling.
2. Contact Service.
2.8006.65
3
462 AL Coolant EMU L1
Alarm configuration limit val-
ue; EMU coolant temperature
value too high / low.
Check configura-
tion with DiaSys.
2.8006.65
4
463 SD AUX 2
SD alarm configuration; Ana-
log input signal for Aux 2
faulty; Short circuit or wire
break
Check signal trans-
mitter and cabling,
replace as necessa-
ry.
Error cleared after
restarting the en-
gine.
1.8004.59
1
464 SD P-AUX 1
SD alarm configuration; Ana-
log input signal for Aux 1
pressure faulty; Short circuit
or wire break
Check pressure
sensor and cabling.
Error cleared after
restarting the en-
gine.
1.8004.58
9
M015695/03E 2013-03 | Troubleshooting | 75
TIM-ID: 0000033662 - 001

Table of Contents

Related product manuals