Operating job computer on the field
Tank filling
6
Operating job computer on the field
Tank filling
You must enter the new content of the tank manually.
Tank was fully filled up.
Set tank content to 0 liter.
To enter the new tank content when you have completely refilled the spray liquid tank:
1. Switch to the “Filling - manual ” screen:
⇨ The following screen appears:
2.
- Enter full tank
or
3. In the “New tank content ” box, enter the tank content after refilling.
⇨ The new tank content appears in the work screen, in the tank data area.
If you are using TANK-Control, it will show the current tank content. Automatic tank filling via TANK-
Control is currently not possible.
To Next Page
Loading...