7
Configuring the job computer
Configuring the nozzles - for sprayers with pressure calculation
⇨ The set speed and the flashing icon appear on the work screen.
Configuring the nozzles - for sprayers with pressure calculation
By configuring the nozzle type, the job computer can calculate the current spray pressure based on
the measured flow.
You have to configure the nozzles if a pressure sensor is installed on the sprayer.
If no pressure sensor is installed on the sprayer and the application rate is only regulated based on
the flow, then you only need to configure the nozzles for the pressure calculation.
Nozzle assistant
The nozzle assistant serves the following purposes:
▪ To show how the nozzle type affects the possible application rates and speeds.
▪ To help with the correct selection of the installed nozzle type.
▪ To change the target rate.
Changes the calculated data
Determination of possible application rates
Selected nozzle
Here, you can enter:
- The intended working speed
- The optimal pressure for the nozzle
Here, you can see which application rates are possible with this nozzle at the set working speed.
To Next Page
Loading...
Need help?
General
