Table of contents
Raising and lowering the air cushions
Lifting and lowering the boom
Folding and unfolding the boom
Extending and retracting the boom
Regulating the application rate
Changing the application rate in manual mode
Operating the spraying area via the boom display
Switching the fans on and off
Switching the air compressor on and off
Operating the ME joystick
Preview mode for the ME Joystick
Viewing the assignment of the joystick
Operating additional functions
Configuring the job computer
Entering sprayer parameters
“Working Width” parameter
“Wheel Impulses” parameter
“Minimum Pressure” parameter
“Maximum Pressure” parameter
“Sprayer off Below” parameter
“Regulation off Below” parameter
“Regulation Factor” parameter
“Tank level alarm” parameter
“Impulses Main Flow” parameter
“Circulation Type” parameter
Configuring the control units
Calibrating the flow meter
Calibrating the flow meter with the tank method
Calibrating the flow meter with the nozzle method
Manually entering the number of impulses per liter for the flow meter
Selecting and configuring the speed sensor
Selecting the speed source
Calibrating the speed sensor with the 100m method