MULTIQUIP DCA Series - Inspection Procedures; Engine and Generator Inspection Tasks

GENERATOR SERVICE AND TROUBLESHOOTING MANUAL — REV. #0 (08/29/23) — PAGE 19
ENGINE/GENERATOR INSPECTION
The following is a compiled list of duties performed by
service technicians. Most of the tasks should be done
during normal scheduled maintenance.
ENGINE CHECK/INSPECT
 Air cleaner for restrictions and contaminants. Replace
if necessary.
 Cooling system hoses for cracks and distortions —
tighten clamps or repair as needed.
 Radiator for restrictions and corrosion.
 Engine block heater for leaks and verify unit functioning
properly. Engine block heater is an option on some units.
 Coolant, fuel and oil leaks. Tighten connections or repair
as needed.
 Belts and pulleys for cracks and wear — adjust or repair
as needed.
 Governor and injection pump for leaks and proper
operation.
 Turbocharger for proper clearance and free movement
as required. Reference engine service manual.
 Fuel tank for contaminants and condensation.
 Fuel hoses, piping and connections for chang and
restrictions.
 Line trap, drain as required.
 Hangers, anchors and supports for exhaust system.
 Exhaust system for cracks and leaks.
 Battery charging system including alternator and external
charger (option).
 Battery terminals, clean and apply anti-corrosion
protectant as needed.
NOTICE
For complete engine inspection and service
specifications, consult the Engine Manufactures
"Owners" and/or "Service" Manuals.
GENERATOR CHECK/INSPECT
 Cable ends, wire connectors and terminals, tighten and
repair as needed.
 Generator end for signs of heat discoloration.
 Panel controls and breakers for signs of heat discoloration
and that they are securely mounted.
 All gauges for proper operation during test run.
 Frequency and voltage, adjust as necessary.