Multitech MultiConnect - Page 36

Chapter 4 – Command Line Interface (CLI)
Multi-Tech Systems, Inc. MultiConnect Serial-to-Serial Adapter User Guide (S000354A) 36
Serial Commands – Setup
Command Syntax set serial [s0/s1] modem dial-prefix <dialprefix>
Description
Sets the Modem Dial-Prefix.
Triggers for a reboot upon save.
Note: The configured modem strings takes precedence over the
MODEM.CNF
Default Value
ATDT
Success
OK
Error 1. Too few arguments
"Usage: set serial s0/s1 modem dial-prefix <dialprefix>
Type 'set serial s0/s1 modem dial-prefix ?' for more information"
Command Syntax Set serial [s0/s1] modem dial-suffix <dialsuffix>
Description
Sets the Modem Dial-suffix. Triggers for a reboot upon save.
Note: The configured modem strings takes precedence over the
MODEM.CNF
Default Value
^M
Success
OK
Error 1. Too few arguments
"Usage: set serial s0/s1 modem dial-suffix <dialsuffix>
Type 'set serial s0/s1 modem dial-suffix ?' for more information"
Command Syntax Set serial [s0/s1] modem dialing-method <configuration/chat-script>
Description
Sets the modem dialing method.
1. Configuration method: The user shall provide only the dial-number to
reach.
2. Choosing the 'chat' as the dialing-method, the user can write his/her own
script by providing an Expect and a Send sequence.
Refer to: 'set serial s0/s1 chat-script ?' for providing an "Expect" and a
"Send" sequence.
Triggers for a reboot upon save.
Default Value
Configuration
Success
OK
Error 1. Too few arguments
"Usage: set serial s0/s1 modem dialing-method <configuration/chat-
script>
Type 'set serial s0/s1 modem dialing-method ?' for more information"