Multitech MultiConnect - Page 35

Chapter 4 – Command Line Interface (CLI)
Multi-Tech Systems, Inc. MultiConnect Serial-to-Serial Adapter User Guide (S000354A) 35
Serial Commands – Setup
Command Syntax Set serial [s0/s1] flow-control <none/rts-cts>
Description
Set the flow-control of the serial port. By default flow-control is disabled on
the serial port.
Default Value
rts-cts
Success
OK
Error 1. Too few arguments
“Usage: set serial s0/s1 flow-control <none/rts-cts>
Type ‘set serial s0/s1 flow-control ?’ for more information”
2. Invalid flow-control setting
“error: flow-control supported: [none/rts-cts]
Type ‘set serial s0/s1 flow-control ?’ for more information”
Command Syntax set serial [s0] host-interaction-mode <enable/disable>
Description
This parameter is set by the host to enable the host-interactive-mode.
When this mode is set, the host/serial device can use SMTP client, POP3
client, and HTTP server.
Host interaction mode is valid only for device port S0.
Note: Telnet Auto-Dialout and PPP cannot be enabled when this mode is
enabled.
Default Value
Disable
Success
OK
Error 1. Too few arguments
"Usage: set serial s0 host-interaction-mode <enable/disable>
Type set serial s0 host-interaction-mode ?”
2. Invalid string
Type set serial s0 host-interaction-mode ?”
3. Port used by Auto-dialout
“ERROR: Port used by Auto-dialout”
4. “set serial s1 host-interaction-mode s1” is given
“error: Command not supported on modem port s1”
Command Syntax set serial [s0/s1] modem connect-string <connect-str>
Description
Sets the Modem Connect string.
Triggers for a reboot upon save.
Note: The configured modem strings takes precedence over the
MODEM.CNF
Default Value
CONNECT
Success
OK
Error 1. Too few arguments
"Usage: set serial s0/s1 modem connect-string <connect-str>
Type 'set serial s0/s1 modem connect-string ?' for more information"
Command Syntax set serial [s0/s1] modem dial-number <phone-num>
Description
Sets the dial-number to be dialed.
Default Value
NA
Success
OK
Error 1. Too few arguments
"Usage: set serial s0/s1 modem dial-number <phone-num>
Type 'set serial s0/s1 modem dial-number ?' for more information"