-23-
8.7. Sound Notifications
Menu Function Value Function Description
Ordinal Number in the "Parameters" Hot Menu
Warnings Log Warnings Log
Sound freq. Warnings Log Frequency
Sound off Disabling Sound Notifications
High V batt. High Battery Voltage Notification >BB
Low V batt. Low Battery Voltage Notification >BB
High Speed Notification >BB
High RPM Notification >BB
Fuel rem. Low Fuel Notification >BB
Make TS >B
Econometer >BB
The period of voicing messages in the "Econometer" mode.
Full tank Full Tank Notification >B
%Inj/Exp >B
Fault ECU Fault Notification >B
Coolant Overheat Notification >BB
Eng.overheat
Engine Oil Overheat Notification >BB
Cyl.overheat Cylinders Overheat Notification >BB
Eng.heating Engine Heating Notification >B
Trim >OO
WaterInFuel Watre in the Fuel Notification >BB
Keys sound Mute buttons >BB Mute the sound of pressing the buttons. All other warnings work according to the settings.
Lock sound Disabling the greeting sound each time the ignition is turned on.
№
The log records the latest time of each warning. The log clears up at 00 hours 00 minutes.
Check the log at the end of the trip to analyze emergency situations and monitor events in
case the warning sound is disabled during the trip or you missed a warning message.
2000…5000
>3100
The choice of the tone of sound warnings about the parameters going beyond the limits of the
set value (the less the number - the lower the sound, the more the number - the higher the
sound).
>No
Lock
Yes
No - sound notifications are produced according to the settings.
Lock - mute sound notifications completely, including when pressing the buttons, until the
ignition is turned off. After turning on the ignition, the sound notifications will be enabled.
Yes - mute sound notifications completely, including when pressing the buttons, warning
messages are produced according to the settings.
The first character sets the type of the first alert after the ignition switch is turned on, the
second character sets the type of all subsequent alerts before the ignition switch is turned off.
Repeated pressing on the "SET" button leads to the selection of a group for editing
O - no voice or text messages.
N - no voice warnings, only text messages displayed.
B - a long "Beep" warning sound and a text message displayed.
Exceeded
speed
Speed
thinning
Speed Thinning Notification
(min)
P, 0...99
>0
A speeding warning is blocked for a set period of time if it has been produced several times
during a short period of time.
P - a tone signal sounds when speeding above the limit (Voice messages - Speed Limit) and
the "beep" sound when the speed decreases below the limit. This method allows you to
determine the moment of exceeding the speed limit and returning to the permissible speed
limit by ear, without distracting from monitoring the surrounding situation.
Exceeded
prm
The first character sets the type of the first alert after the ignition switch is turned on, the
second character sets the type of all subsequent alerts before the ignition switch is turned off.
Repeated pressing on the "SET" button leads to the selection of a group for editing
O - no voice or text messages.
N - no voice warnings, only text messages displayed.
B - a long "Beep" warning sound and a text message displayed.
Notification of the sevice
maintenance date
Notification in the "Econometer"
mode
The first symbol programs warning signals in case of an uneconomical trip (fuel
overspending). The second symbol is for an economical trip.
Econom.
Period
1...20
>2
O - no voice or text messages.
N - no voice warnings, only text messages displayed.
B - a long "Beep" warning sound and a text message displayed.
Notification of the Function "Fuel
Quality Control"
Coolant
overheat
Water
overheat
Eng.oil
overheat
Unacceptable Engine Position
(Trim)
Mute Greeting When the Ignition
is Turned on
>On
Off
To Next Page
Loading...