Cleaning
Cleaning recommendations
52 03.06.2014
¾ Store empty, new film pouches outside the room in a clean, dry
place during the cleaning procedure.
¾ Remove all waste (e.g. product scraps, film trim) on or around the
machine.
¾ Remove the following components:
– Sloping insert with with support angle.
– Filling plate.
– Sealing bar, see Section 7.3.1 "REMOVE THE SEALING BAR".
– Insertable counter-pressure bar.
¾ Check chamber lid gasket for dirt or contamination.
¾ If there is dirt or contamination, remove the chamber lid gasket
from the groove.
To Next Page
Loading...
