Cleaning
Cleaning recommendations
03.06.2014 53
¾ Take the removed components to a separate room suitable for
wet cleaning.
¾ Clean dismantled components manually with cleaning solution.
¾ Only clean the Teflon tape of the sealing bar manually with a
soft cloth or a soft brush.
¾ Thoroughly clean the inert gas nozzles.
¾ Wait until the application time has elapsed (see instructions of
cleanser manufacturer).
¾ Wipe with new cloth and water of drinking quality.
¾ Inspect for dirt and cleanser residues.
¾ If necessary, perform another manual cleaning and wipe it off.
¾ Disinfect dismantled components with an alcohol-based disinfec-
tant.
¾ Thoroughly disinfect the inert gas nozzles.
¾ Wait until the application time has elapsed, see instructions of dis-
infectant manufacturer.
¾ Clean the floor with a rubber wiper.
¾ Dispose of the waste properly.
¾ Apply cleanser to the floor in the low-pressure foaming procedure.
¾ Wait until the application time has elapsed (see instructions of
cleanser manufacturer).
¾ Rinse off the floor with water of drinking quality.
¾ Manually clean the entire machine, including the table, with clean-
ing solution.
To Next Page
Loading...
