Cleaning
Cleaning recommendations
54 03.06.2014
¾ If necessary, wipe off the components with a new cloth and water
of drinking quality; see instructions of the disinfectant manufac-
turer.
¾ Clean the floor with a rubber wiper.
¾ Dispose of the waste properly.
¾ Apply cleanser to the floor in the low-pressure foaming procedure.
¾ Wait until the contact time has elapsed (see instructions of
cleanser manufacturer).
¾ Rinse off the floor with water of drinking quality.
¾ Manually clean the entire machine, including the table, with clean-
ing solution.
¾ Only clean the chamber lid manually with a soft cloth or a soft
brush.
¾ Wait until the contact time has elapsed (see instructions of
cleanser manufacturer).
¾ Wipe with new cloth and water of drinking quality.
¾ Inspect the entire machine and the floor for dirt and cleanser resi-
dues.
¾ If necessary, clean and wipe off again.
¾ Disinfect the entire machine, including the table, with disinfectant.
¾ Close the chamber lid. So that the chamber lid remains closed,
first open it as far as the limit stop and then close it.
¾ Use a hand-held spray lance to apply disinfectant to the floor.
¾ Wait until the contact time has elapsed (see instructions of disin-
fectant manufacturer).
¾ If necessary, rinse the floor with water of drinking quality; see in-
structions of the disinfectant manufacturer.
¾ Open the chamber lid. Open the chamber lid more than half way
so that it remains open.
– The chamber lid remains open in the middle position.
¾ If necessary, wipe off the machine with a new cloth and water of
drinking quality; see instructions of the disinfectant manufacturer.
¾ Remove the plastic bag from the mains plug.
¾ Dispose of plastic bags properly. For reasons of hygiene, never
reuse bags
To Next Page
Loading...
