Page34of41
IMC01 Banknote Counter User Manual
Version 1.06
Figure 7-12 The Adjustable Screw
The screw is used to control the width of the feeding gap. The width will become smaller by rotating the screw
toward the smallest dot, otherwise, it will become bigger.
Figure 7-13 Rotate the Screw to Increase the Feeding Gap
Figure 7-14 Rotate the Screw to Decrease the Feeding Gap
Please fine tune the feeding gap by the following steps.
1) Stop the auto counting first.
2) Insert one banknote to the gap between the rollers to check if the banknote can be inserted smoothly, as
shown in the following.
To Next Page
Loading...
