© Munters AB, 2020 76
NOTE Testing takes places at the scheduled time. If there is a delay for any reason (for example, a
power outage), the test will not take place more than five (5) minutes after the scheduled time.
15.2
Viewing the Alarms
•
On the Main Menu bar, click .
•
Click to acknowledge all alarms or acknowledge each one as required.
15.3
Defining the Auxiliary Alarms
The auxiliary alarm provides an additional method for adding alarm functions to specific relays. This
function compares the relay’s current state to its defined state (normally open, normally close). If the relay
is not in its defined state, Trio sends an alarm. You can define the auxiliary alarms to operate during
specific time periods. Use this alarm for those relays controlling important functions.
Define at least one sensor as an auxiliary input. Refer to the Installation Manual.
1. Go to Control > Auxiliary Alarm.
To Next Page
Loading...
Need help?
General
