MUTOH ValueCut Series - Page 39

ValueCut User Manual
The Control Panel 3-4
Set Tangential Mode
Select: OK:ENTER
Enable, Disable
First back to origin
Select: OK:ENTER
Scale Length
Select: OK:ENTER
[TOOL SELECT ]
1S:72 F:80 O:0.275 M
Select: OK:ENTER
Restore default
Select: OK:ENTER
Save parameter
Select: OK:ENTER
Pouncing 0 mm
Select: OK:ENTER
Pouncing:0-200mm with an
increment
of 1mm
OverCut:
0.00mm
Select: OK:ENTER
OverCut:0.00-1.00mm with an
increment
of
0.05mm
Panel Setup
Select: OK:ENTER
Offline For System Setup
Set Smoothing Cut
Select: OK:ENTER
Auto Unrolled Media
Select: OK:ENTER
Vacuum
Select: OK:ENTER
[ MISC ]
English
Select Language
Select: OK:ENTER
Both Expanded Mode、Length Expanded Mode、
Width Expanded Mode、Both Unexpanded Mode
Paper Saving Mode
Select: OK:ENTER
Set Communication
Select: OK:ENTER
AAS Offset
Select: OK:ENTER
Metric (cm/gf) or English
measurement
(inch/oz)
Select Unit
Select: OK:ENTER
Firmware： x.x.xx
FPGA
：
Vx.x mm/dd/yy
Scale Width
Select: OK:ENTER
use to select from 1S to 4S; [ENTER] to adjust the
parameters