ValueCut User Manual
CorelDRAW Plug-In A-4
Multiple Copies
It is suggested to select “Multiple Copies” when you would like to make several copies of one
image on your material to increase cutting accuracy.
Multiple Copies
No. of X Copies: The numbers of copies on X axis
No. of Y Copies: The numbers of copies on Y axis
Range: 1~50. (The more copies you make, the more time is needed
for data transmission.)
Numbers of X Copies * Numbers of Y Copies = The total amount of
image copies
Copies with outline：To show outlines of image graphics
The system will create the as shown in the picture below.
X axis
Y axis
To Next Page
Loading...
