26 Correcting paper feed
[3]
Enter the checked value in Step 2 to [3-2. Micro Change], and click [Start].
• The micro change value is saved.
• This completes the paper feed correction.
Note
The micro change value saved in Step 3 becomes the pattern’s standard value.
For example, if “-0.50” is saved as the micro change value and a pattern is printed again, the number below the center pattern changes from
“0.00” to “-0.50”, and the left edge to “+0.70” and right edge to “-1.70”.
To Next Page
Loading...
Need help?
General