MX T406 - Implement Hitching; Implement Carrier Frame with Manual Locking

31
Subject to modication
9. Implement hitching
This operation must be carried out by the driver, who must exit the cab and ensure all
manoeuvres are prohibited while working on the loader.
9.1 Implement carrier frame with manual locking
— Ensure that the unlocking lever is in the hitching position (lever to
the rear). The pins are back in, the springs are compressed.
CAUTION: Check that the implement's hoses are well clear
of the hitching area.
■
— Approach the loader in line with the implement.
— Fit the implement carrier onto the implement.
— Crowd and continue to advance until the locking lever trips.
■
— Turn o󰀨 the engine.
— Decompress the hydraulic lines supplying the implement.
NOTE: If the loader has a solenoid valve, switch on the ignition and
press the control button.
■