MX T406 - Directions for Use

46
Subject to modication
Tighten fasteners/screws in accordance with the tightening torque recommended in the table below.
(Fasteners/screws used on the tractor must not be tightened using an air gun.)
■
— Tightening torques (Nm)
Class of bolt
Dowel
marking
(ISO 898)
Thread
M 5 M 6 M 8 M 10 M 12 M 14 M 16 M 18 M 20 M 22 M 24 M 27
8.8 5.2 9 21.6 43 73 117 180 259 363 495 625 915
10.9 7.6 13.2 31.8 63 108 172 264 369 517 704* 890 1304
12.9 8.9 15.4 37.2 73 126 201 309 432 605 824 1041 1526
■
21. Directions for use
— Each implement has been designed for a specic use and has its
own resistance limits.
— Land clearing and stump pulling are prohibited. This work must
be done with specialized machinery and is not appropriate for
the agricultural loader.
— Use the tractor's driving power to penetrate into the material to
be moved rather than speed, which subjects the loader and
tractor to high stresses.
— When the load to be moved is too big, do not force on the
hydraulic components. The same applies when the rams are
fully extended. Release the control valve levers.
■
— For ground levelling, work at slow speed with an implement-to-
ground angle of 50° at most.
NOTE: Work exibly and carefully.
■
50˚ max