MX T406 - Safety Lift Ram Stop on Loader; Safety Stickers

48
Subject to modication
■
23. SAFETY LIFT RAM STOP ON LOADER
The lift ram stop must remain permanently attached to the loader.
Install the lift ram safety stop before carrying out any work or maintenance operation under the
raised loader arms. Failure to comply could result in death or serious injury.
Only supplied in case of specic local safety regulations (Code of
Practice, …).
— Empty loader bucket and place it in fully dumped position.
— Raise the loader until the safety ram stop can be positioned on
the lift rod.
— Stop the engine.Install the safety ram stop and strap it onto the
lift rod (1) .
— Slowly lower loader fully down against the safety stop.
Do not continue to lower once it is against the safety stop.
■
1
— Except for operation under the raised loader arms, install the
ram safety stop as in (2) position.
■
2
23.1 SAFETY STICKERS
Safety stickers have to be a󰀩xed to the loader. The Loader should prominently display pictorial and/or written
signs that warn against serious safety risks.