W415-3031 / 04.30.21
EN
14
3.0 finishing
3.1 dark crystal installation
• Power supply service must be completed prior to finishing in order to avoid reconstruction.
• Heat vents and air openings cannot be covered under any circumstances.
!
WARNING
1. Carefully place the dark crystals into the bottom media tray
(Fig. 1).
2. Apply an even layer from side to side.
3. Randomly place the 3 large crystal embers on top of the small
crystal embers.
Fig. 1
The door glass must be removed and the appliance must be secured in its final location before the dark crystals
are installed (see “door glass removal” section).
note:
To Next Page
Loading...
Need help?
General
