Napoleon ASCENT SERIES User Manual

W415-2165 / G / 08.15.18
EN
20
finishing
5.0 finishing
5.1 brick panel installation and removal
A. Slide the panels into place and secure it using the 2 screws (supplied).
B. Ensure the brick panels are positioned properly in the appliance and are not angled or sticking out
from the appliance.
C. To remove the panels, remove the 2 screws.
230
2 screw location
• Power supply service must be completed prior to finishing to avoid reconstruction.
• Heat vents and air openings cannot be covered in any circumstances.
!
WARNING
Side View
Front View

Napoleon ASCENT SERIES Specifications

General

Model	Ascent Series
Category	Indoor Fireplace
Fuel Type	Natural Gas or Propane
Ignition System	Electronic Ignition
Vent Type	Direct Vent
Fireplace Type	Direct Vent Gas Fireplace
Dimensions	Varies by model
Weight	Varies by model
Warranty	Limited Lifetime Warranty
Control Options	Remote Control
Viewing Area	Varies by model