EN
W415-1838 / B / 06.01.20
21
operating instructions
4.3.1 set current day and time
1. Press once. When “MON” (Monday) begins flashing, use to select the current day.
2. Press . When the hour digits begin flashing, use to select the current hour.
3. Press again. When the minute digits begin flashing, use to select the current minute.
4. Press again. The current time is now set.
4.3.2 set ON/OFF time and temperature on a weekly cycle
1. Press . When “MON” begins flashing, press 3 times. When “ON” begins flashing, use to
select the desired hour and minute to turn on the heater. Press at any time to clear the digits
and shut down “ON” timer.
The timer can only be adjusted in 30-minute increments (i.e. 00:00 - 00:30; 00:30 - 01:00, etc.)
note:
2. Press . When “OFF” begins flashing, use to select the desired hour and minute to turn off the
heater. Press at any time to clear the digits and shut down “OFF” timer.
3. Press again. When “18” begins flashing, use to select the desired temperature for Monday.
If the temperature was previously set, those digits will be shown instead of “18”.
note:
4. Press again. When “TUES” appears on the screen and “ON” begins flashing, use to select the
desired hour and minute to turn on the heater for Tuesday.
5. Press again. When “OFF” begins flashing, use to select the desired hour and minute to turn off
the heater for Tuesday.
6. Press again. When “18” begins flashing, use to select the desired temperature for Tuesday.
7. Repeat steps 1 to 6 to set the “ON/OFF” time and temperature for Wednesday, Thursday, Friday,
Saturday, and Sunday.
8. Press or to complete programming, ensuring to aim the remote control at the receiver, located
in the middle of the appliance. The appliance will “beep” once to confirm that programming has been
successful.
4.3.3 open window warning
If the room temperature decreases by 10 degrees within 3 minutes, the appliance will assume there is an open
window nearby. In order to conserve energy, the heater will automatically switch from High Heat to Low Heat, or if
the heater is already at Low Heat, it will turn off completely.
When switching from High Heat to Low Heat, the appliance will beep 3 times and the digital display will flash “88”
3 times before displaying the existing heating status.
When switching from Low Heat to Off, the appliance will beep 3 times and the digital display will flash “88”
continuously.
To reset the heating function, see “operating remote control” section.
To Next Page
Loading...
Need help?
General
