1. Host/MIDI: Selects between the two types of parameter control automation (Host automation
and MIDI automation).
2. Control mapping entry: Displays a new control mapping entry in the mapping list when Add
New... is selected.
• Host mapping: The entry will be labeled Drag to any Knob or Slider.... You can then drag
and drop the selection cross hair onto a parameter control in the user interface. The
relevant parameter control will then be available for automation from within your host
application. For further instruction, consult the relevant documentation of your host
application.
• MIDI mapping: The entry will rst be labeled Use the Controller you would like to add...,
whereby you must turn a knob or move a slider on your MIDI controller. The entry will
subsequently be labeled Drag to any Knob or Slider.... You can then drag and drop the
selection cross hair onto a parameter control in the user interface. The relevant parameter
control will then be assigned to the control element on your MIDI controller. If BATTERY
does not respond to any movement on your MIDI controller, check if the controller is
activated in the MIDI section of the Audio and MIDI Settings dialog, or in the MIDI settings
dialog of your host application. Refer to Routing Page for more information.
3. Selection cross hair: Assigns BATTERY's parameter controls to a control mapping entry via
drag-and-drop.
4. Value control limitation scale: Sets the minimum and maximum values for the parameter
controls that are assigned to a MIDI controller or your host software. For example, this can be
helpful when you want to automate a volume slider with a slider on your MIDI keyboard, but
ensure the volume won't exceed a certain level when the slider is pulled back up.
5. Add New...: Adds a new control mapping entry to the mapping list when selected.
SIDEBAR 18
To Next Page
Loading...
Need help?
General
