You can select the lter type using the Type selector:
• Ldr 1P: 1-pole ladder lter with a -6 dB/octave slope
• Ldr 2P: 2-pole ladder lter with a -12 dB/octave slope
• Ldr 4P: 4-pole ladder lter with a -24 dB/octave slope
• Daft: Aggressive 2-pole lter with a -12 dB/octave slope
The following controls are available in this mode:
• Cutoff: Adjusts the cutoff frequency.
• Reso: Adjusts the resonance amount of the lter. Turning the control to the right makes the
frequency content at the cutoff frequency more pronounced.
• Gain: Adjusts the output level of the lter. Setting Gain to high values can be used to apply a
soft saturation effect. This control is not available when selecting the AR lter types.
11.5.4. Highpass
Highpass mode is a resonant lter that attenuates frequency content below the cutoff frequency,
creating a brighter sound. It offers four different lter types that change the character of the lter.
You can select the lter type using the Type selector:
• Ldr 1P: 1-pole ladder lter with a -6 dB/octave slope
• Ldr 2P: 2-pole ladder lter with a -12 dB/octave slope
• Ldr 4P: 4-pole ladder lter with a -24 dB/octave slope
• Daft: Aggressive 2-pole lter with a -12 dB/octave slope
The following controls are available in this mode:
• Cutoff: Adjusts the cutoff frequency.
• Reso: Adjusts the resonance amount of the lter. Turning the control to the right makes the
frequency content at the cutoff frequency more pronounced.
• Gain: Adjusts the output level of the lter. Setting Gain to high values can be used to apply a
soft saturation effect. This control is not available when selecting the AR lter types.
11.5.5. Bandpass
Bandpass mode is a resonant lter that attenuates frequency content above and below the cutoff
frequency, creating a thinner and more focused sound. It offers four different lter types that
change the character of the lter.
You can select the lter type using the Type selector:
• Ldr 2P: 2-pole ladder lter with a -12 dB/octave slope
• Ldr 4P: 4-pole ladder lter with a -24 dB/octave slope
• SV 2P: 2-pole state-variable lter with a -12 dB/octave slope
• SV 4P: 4-pole state variable lter with a -24 dB/octave slope
The following controls are available in this mode:
EFFECTS PAGE 37
To Next Page
Loading...
