The Filter module.
• Power: Activates/deactivates the lter.
• High Cut: Sets the frequency above which the signal will be attenuated.
• Low Cut: Sets the frequency below which the signal will be attenuated.
10.6. Compressor
A one-knob control feedback compressor to smooth out the audio signal.
The Compressor module contains the following parameters and controls:
The Compressor module.
• Power: Activates/deactivates the module.
• VU meter: Displays the amount of gain reduction in real-time.
• Amount: Adjusts the amount of compression.
10.7. Sends
Contains two knobs that control the amount of the signal to be sent to the delay and reverb units
in the Master page (refer to Master Page).
The Sends module contains the following parameters and controls:
MAIN PAGE 30
To Next Page
Loading...
