2. Go to either the Factory or User submenus and select a preset from the list.
The effect settings contained in the preset are loaded in the module.
11.3. Saturation
The Saturation module emulates the behavior of analog circuits when signal levels go into
overdrive and clipping. This reduces signal peaks and add the same time adds harmonic content
to the signal, creating the warm and full sound associated with analog saturation. When taken to
the extreme, the module can be used to create distortion effects.
This module contains the following parameters and controls:
• Module On/Off: Activates or deactivates the module.
• Preset menu (arrow button): Opens the Preset menu that enables you to load factory presets
or save and recall your own user presets.
• Mode Selector: Selects one of three available saturation modes, Classic, Drums, and Tape.
• Gain: Adjusts the input level of the module, effectively controlling the amount of saturation
applied to the signal.
• Warmth: Adjusts the level of low-frequency content in the signal. This control is only available
in Tape mode.
• HF: Adjusts the cutoff frequency of a low-pass lter applied to the signal. Frequency content
exceeding the cutoff frequency is attenuated. This control is only available in Tape mode.
• Output: Adjusts the output level of the module.
11.4. LoFi
The Lo-fi module decreases the quality of the signal by lowering the resolution or sample rate, and
by adding noise and coloration to it.
This module contains the following parameters and controls:
EFFECTS PAGE 34
To Next Page
Loading...
Need help?
General
