• Gain: Adjusts the output level of the lter. Setting Gain to high values can be used to apply a
soft saturation effect. This control is not available when selecting the AR lter types.
15.5.4. Highpass
Highpass mode is a resonant lter that attenuates frequency content below the cutoff frequency,
creating a brighter sound. It offers four different lter types that change the character of the lter.
You can select the lter type using the Type selector:
• Ldr 1P: 1-pole ladder lter with a -6 dB/octave slope
• AR 2P: 2-pole ladder lter with a -12 dB/octave slope
• AR 4P: 4-pole lter with a -24 dB/octave slope
• Daft: Aggressive 2-pole lter with a -12 dB/octave slope
The following controls are available in this mode:
• Cutoff: Adjusts the cutoff frequency.
• Reso: Adjusts the resonance amount of the lter. Turning the control to the right makes the
frequency content at the cutoff frequency more pronounced.
• Gain: Adjusts the output level of the lter. Setting Gain to high values can be used to apply a
soft saturation effect. This control is not available when selecting the AR lter types.
15.5.5. Bandpass
Bandpass mode is a resonant lter that attenuates frequency content above and below the cutoff
frequency, creating a thinner and more focused sound. It offers four different lter types that
change the character of the lter.
You can select the lter type using the Type selector:
• Ldr 2P: 2-pole ladder lter with a -12 dB/octave slope
• Ldr 4P: 4-pole ladder lter with a -24 dB/octave slope
• AR 2P: 2-pole ladder lter with a -12 dB/octave slope
• AR 4P: 4-pole lter with a -24 dB/octave slope
• Daft: Aggressive 2-pole lter with a -12 dB/octave slope
The following controls are available in this mode:
• Cutoff: Adjusts the cutoff frequency.
• Reso: Adjusts the resonance amount of the lter. Turning the control to the right makes the
frequency content at the cutoff frequency more pronounced.
• Gain: Adjusts the output level of the lter. Setting Gain to high values can be used to apply a
soft saturation effect. This control is not available when selecting the AR lter types.
15.5.6. Peak/Notch
Peak/Notch mode is a resonant lter that can create either peaks or notches in the frequency
spectrum. It offers four different lter types that change the character of the lter.
You can select the lter type using the Type selector:
MASTER PAGE 62
To Next Page
Loading...
Need help?
General
