• Module On/Off: Activates or deactivates the module.
• Mode selector: Selects either the algorithmic (envelope symbol, right) or the convolution reverb
(waveform symbol, left) mode. The following sections describe each of the modes in detail.
• Return: Adjusts the output level of the effect.
15.3.1. Convolution Mode
• Size: Adjusts the swell and reflection pattern of the reverb effect, creating the impression of
differently sized spaces. Turning the control to the right changes the size from small to large.
• HP: Adjusts the cutoff frequency of the high-pass lter applied to the effect signal.
• LP: Adjusts the cutoff frequency of the low-pass lter applied to the effect signal.
• Convolution display: Click the arrow-shaped buttons next to the display to select one of the
presets for the reverb module. You can also drag and drop samples from the Library Browser,
or .wav les from your desktop directly onto the display to use them as reverberation
templates for the convolution reverb.
• Reverse: Reverses the impulse response.
MASTER PAGE 58
To Next Page
