3. Quick Access controls: This area controls the basic sonic characteristics, and the MIDI key
assignments of the selected cell(s).
• Tune knob: Changes the pitch of the cell and all sample layers contained, with a range of
+3 to-3 Octaves. Turn the knob right to raise the pitch up, and turn the knob left to decrease
the pitch down. Hold [Shift] while turning the know to nely adjust the parameter.
• Reverse button: Click this button to reverse playback for the cell (and all sample layers
contained).
• Pan knob: Click + drag this knob to position the cell in the stereo eld. [Shift] + click + drag
to nely adjust this parameter.
• Level meter/slider: Monitors the cell's output level. Click and drag the slider up/down to
adjust the level. [Shift] + click + drag to nely adjust this parameter.
• Key Range control: Determines the MIDI note(s) that trigger the cell. For example, a Key
Range of C2 / C2 means that the cell will play only upon receiving data from MIDI note C2.
If you set it to C1 / E1, then all notes in that range will trigger the cell, i.e., C1, C#1, D1, D#1,
and E1. You can double-click the eld and enter an alphanumeric value, or click the Learn
button (MIDI icon) and press two keys on your keyboard, one after the other. Make sure the
Selection Follows MIDI Input button in the Header is deactivated when using the Learn
button, otherwise the cell focus will switch to another cell when pressing a key on your
keyboard. See also, Header.
• Phase Invert button: Inverts the phase of the cell.
• L/R Swap button: Swaps the stereo channels of the cell.
QUICK ACCESS AREA 25
To Next Page
Loading...
Need help?
General
