To Next Page

To Previous Page

Bear in mind that all your actions affect a Floating Loop (and not the original Stored Loop, if

any). Hence, if you plan to use the modified Loop later, don’t forget to store it! For example,

you can do this by pressing an unlit CUE/REMIX SLOTS button (see section ↑7.5, Using the

CUE/REMIX SLOTS Section).

7.4.3 Loop SIZE Encoder

The Loop SIZE encoder.

The Loop SIZE encoder allows you to select/adjust the Loop size and to set a Floating Loop

with the selected size:

LOOP SIZE encoder No Loop active Loop active

Turn Selects a Loop size (in beats) for the

next Floating Loop that you will set. The

selected Loop size is displayed in the

Loop Control section in TRAKTOR.

Halves/doubles the Loop’s size.

Push Sets and activates a new Floating Loop

at the current playback position with the

selected Loop size.

Deactivates looping.

A Track Deck's Loop Size display in the TRAKTOR software.

You may have noticed that pushing either of the Loop MOVE and Loop SIZE encoders acti-

vates/deactivates looping.

The only difference when activating looping via the Loop SIZE

encoder is that you additionally set a new Floating Loop at the current position.

Bear in mind that all your actions affect a Floating Loop (and not the original Stored Loop, if

any).

Hence,

if you plan to use the modified Loop later, don’t forget to store it! For example,

you can do this by pressing an unlit CUE/REMIX SLOTS button (see section ↑7.5, Using the

CUE/REMIX SLOTS Section).

Hardware Control Reference

Using the LOOP Section

Traktor Kontrol S2 - Manual - 110

Native Instruments TRAKTOR KONTROL S2 User Manual

Other manuals for Native Instruments TRAKTOR KONTROL S2