13.3 FX Unit Quick Reference
See section ↑7.8, Using the FX Units for more details on these control elements.
Control element Single mode Group mode
FX On button Normal: activates/deactivates FX Unit
globally (lit when activated).
SHIFT: selects next FX from FX list (as
set in Preferences > Effects > FX Pre-
Selection).
Normal: not used.
SHIFT: loads a set of three predefined FX
(as set in Preferences > TRAKTOR KON-
TROL S2 > S2 Control Options > Direct
FX 1-3).
FX DRY/WET knob Adjusts the ratio between unprocessed (dry) signal and processed (wet) signal.
FX Knob 1-3 FX parameter 1-3 (FX-dependent). Parameter for 1st, 2nd, and 3rd FX.
FX Button 1-3 FX Button 1: resets all FX parameters
to their default value.
FX Buttons 2 and 3: FX-dependent (lit
when activated).
SHIFT + button: loads a predefined FX
(as set in Preferences > TRAK-
TOR KONTROL S2 > S2 Control Op-
tions > Direct FX 1-3).
Activates/deactivates FX slot 1-3 (lit when
slot activated).
SHIFT + button: loads in this slot the next
FX from FX list (as set in Preferences > Ef-
fects > FX Pre-Selection).
13.4 Browsing, Loading and Copying Quick Reference
See section ↑7.9, Browsing, and Loading for more details on these control elements.
Appendix C – Quick References
FX Unit Quick Reference
Traktor Kontrol S2 - Manual - 173
To Next Page
Loading...
