◦ When no Loop is active, the LOOP IN button sets a Floating Cue Point, whereas the
LOOP OUT button sets a Loop Out Point and activates a Floating Loop between the
Floating Cue Point (acting as Loop In Point) and this Loop Out Point.
◦ When a Loop is active, holding one of these buttons while spinning the jog wheel al-
lows you to move the corresponding Loop In Point or Loop Out Point.
▪ Auto Loop : When this option is selected, the buttons have auto looping functions:
◦ When no Loop is active, the LOOP IN and LOOP OUT buttons set and activate a 4-
beat and an 8-beat Floating Loop, respectively.
◦ When a Loop is active, the LOOP IN button halves the Loop’s size while the LOOP
OUT button doubles it.
Tempo Faders
The Tempo Faders setting allows you to switch the tempo faders between Absolute mode and
Relative mode.
The Tempo Faders setting.
The tempo fader is described in section ↑7.3, Using the Tempo Unit.
▪ Absolute
(default):
The tempo fader in the software Deck directly mirrors the tempo fader
position on your S2 (see detailed description in section ↑7.3, Using the Tempo Unit).
▪ Relative : The tempo fader on your S2 affects the tempo fader on the software Deck rela-
tively to its current position, even if this position does not match the position of the tem-
po fader on your hardware. This has the benefit of solving all possible offset-related issues
occurring when you change the software Deck’s tempo by any other means (e.g. synchro-
nizing the Deck to another tempo, switching the Deck focus, or moving the tempo fader in
the software):
◦ There is no more risk of any tempo jump when you touch the tempo fader.
Customizing TRAKTOR KONTROL S2
Settings and Preferences for the S2 Control Elements
Traktor Kontrol S2 - Manual - 138
To Next Page
Loading...
Need help?
General
