Confidential and proprietary information of NCR.
Unauthorized use, reproduction and/or distribution is strictly prohibited.
60
BIOS Updating Procedure
Introduction
The BIOS is located in the Serial Peripheral Interface (SPI) chip on the processor
board. This chapter discusses procedures on how to update the terminal SPI
and/or BIOS. The update software is distributed via the NCR Website:
http://www5.ncr.com/support/support_drivers_patches.asp
The BIOS update can be performed using the following methods:
l
Bootable USB Memory Device
l
Windows Flash Executable
Prerequisites
The following are required to perform a SPI/BIOS update:
l
USB Alphanumeric Keyboard
l
BIOS Software – Download from the NCR
Website:http://www5.ncr.com/support/support_drivers_patches.asp
USB Flash Key update prerequisites
l
USB Flash Key with sufficient space for the update files.
l
USB port on the terminal to be updated.
Note
Enable the USBPort in the BIOS (via BIOS Setup).
Windows Flash Executable update prerequisites
l
There should be no other programs running while the BIOS/SPI is updating.
l
The Windows Flash Executable is designed to run from an Administrator
account.
To Next Page
Loading...
Need help?
General
