NCR P1235 - Software Staging Instructions; 7.5 Software Staging Instructions of a New Install; e*SmartClock Pre-Staging; McDonalds COE Staging Screen Configuration

NCR P1235 e*SmartClock Installation Guide, Ver. 1.1
US-IT Restaurant Architecture Team
Page 18 of 37 12/6/16
7.5 Software Staging Instructions of a New Install
The Staging instructions cover a first time e*SmartClock installation. For a new installation, the Installer should
follow all the steps outlined below.
Step Step Description Pictures
e*SmartClock Pre-Staging
1.
E
nsure network connections are
connected
2.
E
arly production units may not have the
image pre-loaded. Use Appendix F and
the Imager 3.5 thumb drive to load the
image
3.
P
ower
ON
the
e
*
S
martClock
Notes:
• The e*SmartClock will do a normal
Windows boot
• The application will try to find a
“hosts” file on the restaurant LAN
• The software staging process should
take 10 – 20 minutes
4.
O
n successful completion of
step
-
2
,
t
he
McDonald’s COE staging screen should
be shown
If you see ‘Assign IP address Manually’
screen, it indicates that host network
connectivity may not have found
Verify network LED indicator are
flashing green on the Ethernet port to
ensure network connectivity between
e*SmartClock and POS switch
Once network connection is verified,
reboot the device, If problem still
persists then contact Installation
Support.
e*SmartClock connected to the network