NCR P1235 e*SmartClock Installation Guide, Ver. 1.1
US-IT Restaurant Architecture Team
Page 5 of 37 12/6/16
1. Overview
This installation document is intended to provide detailed installation instructions for the successful installation of
the e*SmartClock solution on a wall mounted bracket.
2. Installation Readiness
• The e*SmartClock wall mount will require a footprint of the following:
o Without Printer: 20”x 17” (height x width)
o With Printer: 30” x 17” (height x width)
• If installing a printer, two free IG outlets should be available within 5 feet of Installation location
o e*SmartClock
o Printer (Optional)
• Ensure open network port available on POS switch for 50’ patch cable that will run directly from the clock
to POS switch
3. Staging Files Readiness (pre-steps)
• 7 Days Before Install: (Via MOST) Run the Query First
• 7 Days Before Install: (Via MOST) Run the “Fix” (If necessary)
• 7 Days Before Install: (Via MOST) Rerun the Query to confirm the fix was successful (only if the fix was needed)
• Day of Install: (Via MOST) Rerun the Query to confirm the fix is still in Place
4. Install Overview
• Store Manager should perform store close operations before installation.
• Installation should take place by a Certified OTP 2, 3 or professional installer.
• Installation instructions need to be repeated for each new device installed.
ESTIMATE TIME TO COMPLETE INSTALLATION IS APPROX. 60 to 90 MINUTES
“Unapproved devices such as cellular phones or MP3 players should never be plugged into open USB
ports on registers, servers, etc. Connecting foreign objects is a risk and can lead to unwanted
behaviors that can cause damage to store operations. Only approved hardware devices are allowed
to be connected to restaurant technology equipment.”
5. Installation Tools
The installer will need the following tools for e*SmartClock installation
• Power drill
• Drill bits; Depending on the type of wall and tile, select the appropriate drill bit
• Phillips screwdrivers
• Wire cutters
• Tape measure
• Stud Finder
• Level
• Other tools as needed to run and terminate network drop
• McDonald’s Imager 3.5 thumb drive
To Next Page
Loading...
