NCR RealPOS 40 - Page 93

Chapter 5: BIOS Updating Procedures 5-5
Option3–UpdateofBIOS–AlwayspromptsforSerial/Model/Class
ThisoptionpromptsforClass/Model/Serialinformationatthebeginningofthe
programandthenupdatestheBIOS.
1. HighlightOption3andpress[ENTER].
2. Atthepromptpress[ENTER]toentertheClass/Model/SerialNumber
information(DMI).Followtheonscreenformatin
structions.
Example:
7610-1000-8801[ENTER]
54-19378230[ENTER]
3. Press1toconfirmthedataandtocontinue.
4. TheFlashProgramupdatestheBIOSandautomaticallyrebootstheterminal.
Option4–UpdateBIOS–DefaultSerial/Model/Classinformation
ThisoptionisforServicePersonnelonly.ItupdatestheBIOSbutleavesthe
Class/Model/Serialfieldsempty(erased).TheDM
Iinformationisthenenteredwhen
theboardisinstalledinaterminal.
1. HighlightOption4andpress[ENTER].
2. TheBIOSareupdatedandthesystemreboots.
3. RemovetheBIOSUpdatemediabeforethesystemboots.
4. Systemisreadyforoperation.