NCR RealPOS 7199 - IP Address Automatic Acquisition; TCP;UDP Setting

Configuration Network 7-123
IP Address Automatic Acquisition
When "DHCP" is enabled, the printer automatically gets the IPaddress, the Subnet Mask
and the Default Gateway from a DHCP server. If the printer fails to automatically get the
IPaddress, it uses the same IPaddress as the Manual mode. The DHCP allocated IP
address can be seen on the Diagnostics Form of the connected printer.
TCP/UDPSetting
Items
Default
Value
Detail
Number of TCP
Connections
1 Select the maximum number hosts that can be
connected. (1–6)
Time of Time–
out (for Link
Down)
120
min
Set time of time–out for link down. (0–120 min).
When this value is 0, Time–out disables.
Time of Time–
out (for Idle)
2 min Set time of time–out for Idle. (0–120 min).
When this value is 0, Time–out disables.
Real Time
Command
TCP Select protocol of Real Time command. (TCP/UDP)
TCPport 9100 Set port number of TCPRAW.
This port number range is 1024 to 65535.
When "Real Time Command" setting isTCP, it is
used by sending and receiving of Real Time
Command.
UDPport 3000 Set port number of UDPcommand.
This port number range is 1024 to 65535.
This is effective when "Real Time Command"
setting is UDP.