Section 2: Customizing Features
DS1000/2000 Quick Setup Guide Section 2: Customizing Features ◆ 2-9
2
Feature Quick Steps
To cancel the Caller ID display and return your phone to its normal display:
1. Press CLEAR.
To turn the Caller ID display back on (after you press CLEAR to cancel it):
1. Press
CHECK.
To display the Caller ID data for the third party’s call (i.e., use Third Party Caller ID Check):
1. Press
ICM + CHECK.
2. Press the key for the call you want to check.
You can press a line key, loop key, Call Coverage key, or Hotline key:
- Press a line k
ey while the call is ringing or connected to the third party.
- Press a loop k
ey or Call Coverage key while the call is ringing the third party.
- Press a Hotline k
ey while the call is connected to the third party.
3. Hang up when you are done.
To review your Caller ID log:
Your Ring/Message Lamp (the large green LED on the upper right corner of your phone) winks
on (green) when you have Caller ID records you have not reviewed.
At
Your 22-button and 34-Button Display Keyset
1. Press CLnn.
2. Press ALL to review all your records.
OR
Press
UNAN to review records for calls that rang your phone but were unanswered in the system.
3. Press VOL Up or VOL Down to scroll through your Caller ID records.
Press CHECK to toggle your display between its two Caller ID display modes.
4. Press
DIAL to call the person back.
At
Your Super Display Keyset
1. Press CALLS nn.
2. Press
VIEW
ALL
to review all your records.
OR
Press
VIEW
UNANS
to review records for calls that rang your phone but were unanswered in the system.
OR
Press
VIEW ANS
to review the records just for calls that rang you phone that were answered in the system.
3. Press VOL Up or VOL Down to scroll through your Caller ID records.
4. Press CALLBACK to call the person back.