Section 2: Customizing Features
DS1000/2000 Quick Setup Guide Section 2: Customizing Features ◆ 2-29
2
2. Enter 1101 + HOLD. You see:
3. Enter the number of the system bin you want to program (200-299) +
HOLD. You see:
4. Enter the trunk number (e.g., 1) you want the system to use when dialing the stored number +
HOLD.
OR
Enter the Trunk Group number (90-98) you want the system to use when dialing the stored number +
HOLD.
OR
Press
ICM + HOLD if you want to enter Intercom codes. You see:
5. Enter the System Speed Dial number for the selected bin +
HOLD. You see:
The Speed Dial number can be up to 32 digits long. If the number is longer than 16 digits, it
automatically uses the next adjacent bin in addition to the bin you are programming.
6. Enter the name for the selected bin +
HOLD.
See Keys for Entering Names below for more.
7. Go back to step 3 and select another bin to program.
OR
Press
CONF to exit program 1101.
1101:SYSTEM SPD DIAL
BIN?nnn
1101:SPDL BIN:nnn
LINE/GRP/ICM:n
1101:SPDL BIN:nnn
NUM?nnnnnnn
1101:SPDL BIN:nnn
NA?nnnnnnn
To Next Page
Loading...
Need help?
General
