Section 2: Customizing Features
2-30 ◆ Section 2: Customizing Features DS1000/2000 Quick Setup Guide
Feature Quick Steps
Personal Speed Dial
To Program a Personal Speed Dial Number:
1. Dial #SP.
2. Dial the Personal Speed Dial bin number (701-720). or
Press Personal Speed Dial Key (for bins 1-10), or
Press
DIAL and the Personal Speed Dial Key for bins 11-20.
3. Press HOLD.
4. Enter the trunk number (e.g., 1) you want the system to use when dialing your stored number,
OR
Enter the Trunk Group number you want the system to use when dialing your stored number (e.g., 90)
OR
Skip this step if you want to enter Intercom codes.
5. Press
HOLD + Enter the number you want to store + Press HOLD.
The Speed Dial number can be up to 32 digits long. If the number is longer than 16 digits, it
automatically uses the next adjacent bin in addition to the bin you are programming.
6. Enter a name for the Speed Dial number + Press
HOLD.
Name Programming
Press a key the indicated number of times for desired character
Key 1 Time 2 Times 3 Times 4 Times 5 Times 6 Times 7 Times 8 Times 9 Times
1 &- / ‘ 1
2 ABCa b c 2
3 DEFd e f 3
4 GH I g h i 4
5 JKL j k l 5
6 MNOmn o 6
7 PQRSpq r s 7
8 TUV t uv 8
9 WXY Zw x y z 9
0 space : 0
#
Not used
*
Not used
After selecting a letter, press a key for another letter or wait 2 seconds for the cursor to automatically advance.
Additional Name Programming Options
HOLD
Save name. In system programming, HOLD saves and exits name programming.
CONF
Exit name programming without saving name.
VOL Up
Scroll the cursor to the left.
VOL Dn
Scroll the cursor to the right.
MW
Put the cursor after the last entry.
LND
Delete the character under the cursor.
FLASH
Delete the character to the right of the cursor.
CLEAR
Clear the entire entry.
CHECK
Restore the previous entry,
To Next Page
Loading...
Need help?
General
