NEC Dterm Series i User Manual

– 63 –
To cancel
Press Speaker. Receive dial tone. If cancelling for another station, press
MULTILINE APPEARANCE.
Press FWD-NA or dial “Call Forwarding – Don’t Answer” cancel code.
Receive service set tone. LED goes out at your station (or the D
term
of the
multiline station).
Press Speaker. Call Forwarding – Don’t Answer is cancelled.
Logged Out IP Station – Call Destination
To set
Lift handset or press Speaker key.
Press the FDL Key or dial “Logged Out IP Station – Call Destination” access code.
Dial destination station number; receive service set tone.
Replace handset or press Speaker key.
Logged Out IP Station – Call Destination is set.
Using the Soft Key
Press FDL Soft Key; receive special Dial Tone.
Dial destination station number.
Receive service set tone; “FORWARD SET” is displayed.
To verify (with D
term
4D/8D/16D/16LD/32D)
Press “Logged Out IP Station – Call Destination” feature key lit red or press
FDL.
Display indicates the station number calls are forwarded.
Note: With Soft Key Operation, FDL flashes on the display.
4:26 PM TUE 13 APR 2004
FORWARD CANCEL
4:26 PM TUE 13 APR 2004
FORWARD SET XXXX
4:26 PM TUE 13 APR 2004
FORWARD SET XXXX
MIC >>>
4:26 PM TUE 13 APR 2004
FORWARD XXXX

NEC Dterm Series i Specifications

General

Type	Digital Telephone
Speakerphone	Yes
Headset Jack	Yes
Dimensions	Varies by model
Weight	Varies by model
Display	LCD
Programmable Buttons	Yes
Power Supply	Powered by the phone system
Memory	Varies by model