SSA CLI 43
Queue Depth: Automatic
Monitor and Performance Delay: 60 min
Elevator Sort: Enabled
Degraded Performance Optimization: Disabled
Inconsistency Repair Policy: Disabled
Write Cache Bypass Threshold Size: 1040 KiB
Wait for Cache Room: Disabled
Surface Analysis Inconsistency Notification: Disabled
Post Prompt Timeout: 15 secs
Cache Board Present: True
Cache Status: OK
Cache Ratio: 10% Read / 90% Write
Drive Write Cache: Disabled
Total Cache Size: 2.0 GB
Total Cache Memory Available: 1.8 GB
No-Battery Write Cache: Disabled
SSD Caching RAID5 WriteBack Enabled: True
SSD Caching Version: 2
Cache Backup Power Source: Batteries
Battery/Capacitor Count: 1
Battery/Capacitor Status: OK
SATA NCQ Supported: True
Spare Activation Mode: Activate on physical drive failure (default)
Controller Temperature (C): 43
Capacitor Temperature (C): 38
Number of Ports: 2 Internal only
Encryption: Disabled
Express Local Encryption: False
Driver Name: SmartPqi.sys
Driver Version: 63.30.0.64 Pass 1
PCI Address (Bus:Device.Function): 5E:00.0
Negotiated PCIe Data Rate: PCIe 3.0 x8 (7880 MB/s)
Controller Mode: Mixed
Port Max Phy Rate Limiting Supported: False
Latency Scheduler Setting: Disabled
Current Power Mode: MaxPerformance
Survival Mode: Enabled
Sanitize Erase Supported: True
Sensor ID: 0
Location: Capacitor
Current Value (C): 38
Max Value Since Power On: 38
Sensor ID: 1
Location: ASIC
Current Value (C): 43
Max Value Since Power On: 43
Sensor ID: 2
Location: Unknown
Current Value (C): 39
Max Value Since Power On: 39
Primary Boot Volume: None
Secondary Boot Volume: None
Example 2:
To Next Page
Loading...
