NEC PX700W - Performing Lens Calibration

17
2. Projecting an Image (Basic Operation)
2. Press the (POWER)buttonontheprojectorcabinet
orthePOWERONbuttonontheremotecontrol.
The POWER indicator will turn to blue and the projector
will become ready to use.
TIP:
• Whenthemessage“PROJECTORISLOCKED!ENTERYOUR
PASSWORD.” is displayed, it means that the [SECURITY]
featureisturnedon.(→ page 42)
• When the ECOmessage isdisplayed,it meansthat [ON] is
selectedfor[ECOMESSAGE].(→ page 119)
After you turn on your projector, ensure that the computer
or video source is turned on.
NOTE:Thelogoscreen([LOGO]background)isdisplayedwhenno
signalisbeinginput(byfactorydefaultmenusettings).
Performing Lens Calibration
Afterinstallationorreplacementofthelens,besuretoperform
[CALIBRATION]bypressingandholdingtheORIENTATION
buttonforatleasttwoseconds.Calibrationcorrectsthead-
justablezoomandfocusrange.Ifcalibrationisnotperformed,
youmaynotbeabletogetthebestfocusandzoomevenif
youadjustthefocusandzoomforthelens.
• Thefollowinglensesneedcalibration:
 NP16FL,NP17ZL,NP18ZL,NP19ZL,NP20ZL,NP21ZL
Standby Blinking PowerOn
Steady orange
light
Blinking blue
light
Steady blue
light
(→page227)