Issue 5.0 UNIVERGE SV8100
1 - 1130 Voice Response System (VRS)
22-15-06 VRS Delayed Message for
Department Group – Tone Kind
at Message Interval
For each Department Group,
determine what the caller hears
between messages (0 = Ringback
Tone, 1 = MOH, 2 = BGM). This
program is also used for VRS
Waiting Message.
0 = Ring Back Tone
1 = MOH Tone
2 = BGM Source
(default = 0)
22-15-07 VRS Delayed Message for
Department Group – Disconnect
Time After the End of VRS
Waiting Message
For each Department Group, set
how long the system waits after
playing the VRS message before
disconnecting the call (0~64800
seconds). To prevent the call from
disconnecting, set this option to
“0”. This program is also used for
VRS Waiting Message.
0 = No Disconnect
1~64800 Seconds
(default = 60 seconds)
24-02-03 System Options for Transfer –
Delayed Call Forwarding Time
Set how long a telephone rings
before the call reroutes to the
programmed destination.
0~64800 (seconds)
(default = 10)
25-01-02 VRS/DISA Line Basic Data Setup
– DISA User ID
Select whether or not the DISA
User ID is to be used.
0 = Off
1 = On
(default = 1)
25-02-01 DID/DISA VRS Message For each Night Service mode,
enter 1 at the “Talkie” prompt if
trunk should be automatically
answered by VRS and the
message number the caller should
hear (1~100).
0 = No Message
1 = 01~100 (VRS
Messages)
2 = 01~4 (ACI Group
Number)
3 = 01~64 (Extension
Group Number)
(default = 0)
25-03-01 VRS/DISA Transfer Ring Group
With Incorrect Dialing
Set the destination that Automated
Attendant (OPA) calls ring if the
OPA caller dials an incorrect
extension number. This also sets
the options for DISA calls. The
system allows Ring Groups or
Disconnect = 0.
Ring Groups:
1~100
Trunk Ports:
001~200
Day/Night Mode:
1~8
0 (Disconnect)
1~100 (Incoming Ring
Group)
102 (In-Skin/External
Voice Mail or InMail)
(default = 0)
104 (Speed Dial table
Program 25-15-01)
Version 3 software or
higher is required.
(default = 0)
Program
Number
Program Name Description/Comments Assigned Data
To Next Page
Loading...
