NEC Univerge SV8100 - Page 273

UNIVERGE SV8100 Issue 5.0
Class of Service 1 - 263
20-08-15 Class of Service Options
(Outgoing Call Service) – Block
Outgoing Caller ID
Turn Off (0) or On (1) a user Class
of Service from automatically
blocking outgoing Caller ID
information when a call is placed.
If block is enabled, the system
automatically inserts the Caller ID
block code
*67 (defined in
Program 14-01-21) before the
user dialed digits (this requires
Program 14-02-10 to be enabled).
If block is disabled, the system
outdials the call just as it was
dialed by the user.
0 = Off
1 = On
(default = 0 for
COS 1~15)
20-08-16 Class of Service Options
(Outgoing Call Service) – Display
E911 Dialed Extension Name and
Number
Turn off or on an extension ability
to display the name and number of
the extension that dialed 911.
0 = Off
1 = On
(default = 0 for
COS 1~15)
20-08-17 Class of Service Options
(Outgoing Call Service) – ARS
Override of Trunk Access Map
Turn off or on an extension user
ability to override the trunk access
map programming for outgoing
calls.
0 = Off
1 = On
(default = 0 for
COS 1~15)
20-08-19 Class of Service Options
(Outgoing Call Service) – Hotline
for SPK
Turn off or on an extension user
ability to activate hotline or
ringdown when pressing the
Speaker key.
0 = Off
1 = On
(default = 0 for
COS 1~15)
20-08-20 Class of Service Options
(Outgoing Call Service) – Hot
Key Pad
Turn On (1) or Off (0) the ability of
an extension to make a call by just
dialing the number without first
going off hook.
0 = Off
1 = On
(default = 0 for
COS 1~15)
20-08-21 Class of Service Options
(Outgoing Call Service) –
Automatic Trunk Seizing by
Pressing Speaker Key
Used to enable or disable the
ability to access trunks when
going off hook by pressing the
speaker key for each Class of
Service.
0 = Off
1 = On
(default = 0 for
COS 1~15)
20-08-22 Class of Service Options
(Outgoing Call Service) – Voice
Over to busy Virtual Extension
Used to enable or disable the
ability to make voice over to a
busy virtual extension for each
Class of Service.
0 = Off
1 = On
(default = 0 for
COS 1~15)
Program
Number
Program Name Description/Comments Assigned Data