NEC Univerge SV8100 - Page 277

UNIVERGE SV8100 Issue 5.0
Class of Service 1 - 267
20-11-13 Class of Service Options (Hold/
Transfer Service) – Operator
Transfer After Hold Callback
Turn off or on an extension ability
to have a call which recalls from
hold transfer to the operator.
0 = Off
1 = On
(default = 0 for
COS 1~15)
20-11-14 Class of Service Options (Hold/
Transfer Service) –
Trunk-to-Trunk Transfer
Restriction
Turns Off (0) or On (1) the
Trunk-to-Trunk Transfer
Restriction. If enabled,
Trunk-to-Trunk Transfer is not
possible.
0 = Off
1 = On
(default = 0 for
COS 1~15)
20-11-15 Class of Service Options (Hold/
Transfer Service) – VRS
Personal Greeting (Message
Greeting)
Turn off or on an extension user
ability to dial Service Code 716 to
record, listen to or erase the
Personal Greeting Message.
0 = Off
1 = On
(default = 1 for
COS 1~15)
20-11-16 Class of Service Options (Hold/
Transfer Service) – Call Redirect
Turn On (1) or Off (0) a multiline
terminal user ability to transfer a
call to a predefined destination
(such as an operator, voice mail,
or another extension) without
answering the call.
0 = Off
1 = On
(default = 1 for
COS 1~15)
20-11-17 Class of Service Options (Hold/
Transfer Service) – Department
Group Trunk-to-Trunk Transfer
(Each Telephone Group
Transfer)
Turn On (1) or Off (0) the ability of
an extension in a Department
Group to use the Trunk-to-Trunk
Forwarding service codes.
0 = Off
1 = On
(default = 1 for
COS 1~15)
20-11-18 Class of Service Options (Hold/
Transfer Service) – No Recall
Allow (0) or deny (1) answered
Transferred calls from recalling the
originating extension.
0 = Off
1 = On
(default = 0 for
COS 1~15)
20-11-19 Class of Service Options (Hold/
Transfer Service) – Hold/
Extended Park
Determine whether an extension
Class of Service should allow
normal or extended Park
(0 = Normal for Program 24-01-06,
1 = Extended for Program
24-01-07).
0 = Off
1 = On
(default = 0 for COS
1~15)
20-11-20 Class of Service Options (Hold/
Transfer Service) – No Callback
Turn off or on an extension ability
to receive Callbacks.
0 = Off
1 = On
(default = 0 for
COS 1~15)
20-11-21 Class of Service Options (Hold/
Transfer Service) – Restriction
for Tandem Trunking on Hang Up
Allow (0) or deny (1) an extension
users’s ability to set up a tandem/
conference call automatically
when they hang up.
0 = Off
1 = On
(default = 0 for
COS 1~15)
20-11-22 Class of Service Options (Hold/
Transfer Service) – Restrict
Unsupervised Conference
Allow or deny an extension user to
initiate a Trunk-to-Trunk Transfer
(Tandem Trunking).
0 = Off
1 = On
(default = 0 for
COS 1~15)
Program
Number
Program Name Description/Comments Assigned Data