NEC Univerge SV8100 - Page 519

UNIVERGE SV8100 Issue 5.0
Flexible System Numbering 1 - 509
11-11-17 Service Code Setup (for Setup/
Entry Operation) –
Programmable Function Key
Programming (2-Digit Service
Codes)
Use this option to set the service
code (default 751) to assign 2-digit
function codes to the Function
keys.
MLT
(default = 851)
11-11-18 Service Code Setup (for Setup/
Entry Operation) – BGM On/Off
Use to customize the BGM On/Off
used for registration and setup.
MLT
(default = 825)
11-11-19 Service Code Setup (for Setup/
Entry Operation) – Key Touch
Tone On/Off
Use to customize the key touch
tone Off/On used for registration
and setup.
MLT
(default = 824)
11-11-20 Service Code Setup (for Setup/
Entry Operation) – Change
Incoming CO and ICM Ring
Tones
Use to customize the change
incoming CO and ICM ring tones
used for registration and setup.
MLT
(default = 820)
11-11-21 Service Code Setup (for Setup/
Entry Operation) – Check
Incoming Ring Tones
Use to check incoming ring tones
used for registration and setup.
MLT
(default = 811)
11-11-22 Service Code Setup (for Setup/
Entry Operation) – Extension
Name Programming
Use to customize the Extension
name programming used for
registration and setup.
MLT
(default = 800)
11-11-23 Service Code Setup (for Setup/
Entry Operation) – Second Call
for DID/DISA/DIL
Use to customize the second call
of DID/DISA/DIL used for
registration and setup.
MLT
(default = 779)
11-11-24 Service Code Setup (for Setup/
Entry Operation) – Change
Station Class of Service
Allows an extension user to
change the COS of another
extension. Must be allowed in
Program 20-13-28.
MLT
(default = 777)
11-11-25 Service Code Setup (for Setup/
Entry Operation) – Automatic
Transfer Setup for Each
Extension
Group
Customize the service code to be
used to set the Automatic Trunk
Forwarding feature for a
Department Group.
MLT, SLT
(default = 702)
11-11-26 Service Code Setup (for Setup/
Entry Operation) – Automatic
Transfer Cancellation for Each
Extension Group
Customize the service code to be
used to cancel the Automatic
Trunk Forwarding feature for a
Department Group.
MLT, SLT
(default = 703)
11-11-27 Service Code Setup (for Setup/
Entry Operation) – Destination of
Automatic Transfer Each
Extension Group
Customize the service code to be
used to set the destination for the
Automatic Trunk Forwarding
feature for a Department Group.
MLT
(default = 704)
11-11-28 Service Code Setup (for Setup/
Entry Operation) – Delayed
Transfer for Every Extension
Group
Use to customize the delayed
transfer for every extension group
used for registration and setup.
MLT, SLT
(default = 705)
Program
Number
Program Name Description/Comments Assigned Data