2 - 2 Chapter 2
Chapter 2 - MH240 Setup
2.1.1.3 Place the MH240 in Config Mode
To set administrator-related data such as Network, WLAN and SIP data, place the phone in Config
mode. Config Password entry is required to do this.
1. Press MENU key in Standby mode to display the main menu.
2. Press keys 5 3 1 to go to the “1.Config” menu.
3. Enter Config Password (4 digits, 1234 by default) to view “1.Config” menu then press the
round OK key.
When the phone has been initialized, please enter new Config Password.
2.1.1.4 Keypad Character List
When entering alphanumeric characters on the MH240, use the following chart for reference.
Pressing a dial pad digit repeatedly will scroll through the available alphanumeric characters for the
digit. When the desired character is displayed, you can then press the next digit. Pressing the ab or
12 soft key will toggle the entry from numeric to alphabetic.
2.1.1.5 Soft Key Entry
When soft keys choices are available, they will be shown on the display. Pressing the TRF key
selects the soft key choice on the left. The OK button will accept the choice in the middle. Pressing
HOLD will select the choice displayed on the right.
Digit 1 ? ! * # “
Digit 2 A B C a b c
Digit 3 D E F d e f
Digit 4 G H I g h i
Digit 5 J K L j k l
Digit 6 M N O m n o
Digit 7 P Q R S p q r s
Digit 8 T U V t u v
Digit 9 W X Y Z w x y z
Digit 0 space
*
# .@/(),-_:‘~&\